Design.Cut.Weld.Finish.

Custom metal fabrication for energy and industrial installations — solar mounting structures, equipment frames, enclosures, brackets, tanks and support steelwork. We design, cut, weld and finish to your site’s exact requirements, engineered for the real wind, weight and corrosion loads a component will face, so what we build fits first time and lasts. From rooftop solar mounts to industrial support steelwork, we take a job from measurement and design through to a finished, protected structure ready to install.

Every energy installation eventually meets the same wall: the catalogue part does not fit the real site. A roof at an awkward pitch, a ground array on uneven terrain, an enclosure for a space no standard box was made for, a mounting frame that has to carry a specific load in a specific wind zone. That is where fabrication earns its place. Our workshop designs and builds the steelwork that energy and industrial systems stand on — solar mounting for tile, iron-sheet, flat-concrete and ground-mount, equipment frames and skids, protective enclosures, brackets, tanks and bespoke support structures. We do not simply cut metal to a drawing; we engineer for the loads that matter, sizing and bracing for the wind a structure will actually see, the weight it must carry for decades, and the corrosion it will fight in humid or coastal conditions. Work is measured on site so it fits on the first attempt rather than being forced or re-cut, and finished — galvanised, treated or painted — to survive the environment it lives in. The result is the difference between hardware that is bolted on and hardware that is properly mounted.